Where is the thermostat on a gas dryer?

Operating thermostats control the temperature of the air inside the drum. You may have one or more operating thermostats mounted on the exhaust side of the blower housing. One may be used for the “Normal” drying cycle and will open at the highest temperature.

How do I know if my dryer gas valve is bad?

Locate the gas valve and remove the coil(s) and test them using a multimeter, if you get a resistance reading on the meter of 1000-2000 ohms, the coil is bad and must be replaced.

Can I bypass the thermal fuse on my dryer?

The thermal fuse will look like a thin strip of white plastic with a wire coming out of each end. In order to bypass the thermal fuse, use electrical tape to tape the two ends together. The thermal fuse will then be bypassed. Turn the dryer on to a heat cycle for no more than 90 seconds.

Can a gas valve go bad on a dryer?

What Can Go Wrong? Restricted air flow and overloading your dryer can cause the gas valve solenoids to fail, which may explain your dryer not heating. If your igniter glows red but doesn’t ignite the burner, you most likely need to install a new gas valve assembly.

Is there a pilot light on a gas dryer?

You have to manually light the pilot lights in gas dryers. The last such dryer was manufactured in 1994. Gas dryers have electronic ignition mechanisms that light the burner when the controls call for heat.

Why are my clothes still wet after drying?

A clogged dryer vent often is the reason for damp clothes at the end of a drying cycle. It’s frustrating to toss a load of damp clothing into the dryer only to return to find them as wet as when you put them in. The reason clothes are still wet at the end of a drying cycle might be as simple as a clogged vent.

What goes wrong with gas dryer?

Solution: Several things could be causing this problem: the dryer’s thermal fuse, bad coils on the gas valve, or a blocked vent. To pinpoint the cause, start with a test of the vent because it is easy and there are no parts to replace.

How do you clean a vent on a gas dryer?

If you have a gas dryer, turn the supply valve off while cleaning. Pull the dryer away from the wall about a foot to begin cleaning your dryer vent. Disconnect the dryer duct from the back of the dryer. You may need to use a screwdriver to disconnect the vent clamp.

What’s the best way to clean electrical contacts?

You can use a cleaning solution meant for cleaning electrical contacts, or try a household product, such as: Rubbing alcohol. White vinegar. Nail polish remover. Tip: For hard to reach electrical contacts, you might also try using a can of concentrated air or a pressurized contact cleaner.

What’s the best way to clean an electric dryer?

For an electric dryer, rub the drum with a soft cloth that has been dipped in a mild hand-wash dish soap diluted in very warm water. For a gas dryer, do the same with a liquid, nonflammable household cleaner. For both an electric and gas dryer, rinse well with a wet sponge or towel.

What should I do if my dryer screen is clogged?

Dryer sheets can leave residue on a lint screen that can build up over time. If the lint screen is clogged, use a scrub brush to wash it in warm, soapy water, rinse it with clean water and dry it off with a towel. It’s important to remove lint regularly to avoid lint buildup.