Where is the crankshaft position sensor located on a 2004 Hyundai Santa Fe?

Hi, assuming that you have the 2.7L the crankshaft pulse sensor can be found in the front facing cylinder block just above the starter location. It is held in with a single 6mm hexagon capped screw that needs a 1/4″ drive 10mm A/F socket with a ratchet to remove.

Where is the crank sensor on a 2004?

The crank shaft position sensor is located on the lower portion of the timing cover to the left side of the crank pully if facing the engine. You will see a two wire harness that comes down around the a/c compressor that pluggs into the sensor.

Where is my crankshaft position sensor located?

The crankshaft sensor is usually located near the bottom of the block, toward the front of the engine. In most cases, you’ll find it behind the harmonic balancer. In some vehicles, you might find the crankshaft sensor behind the timing cover, near the bottom of the block, though this is rare.

Are there any recalls on a Hyundai Santa Fe?

Hyundai is recalling over 150,000 Santa Fe Sport SUVs from the 2013 through 2015 model years to fix a faulty part that may cause a fire. The automaker recommends that owners park their vehicles outdoors and away from structures until the problem can be fixed.

What happens if my crankshaft sensor goes bad?

Intermittent stalling Another symptom commonly associated with a problematic crankshaft position sensor is intermittent stalling. If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall.

Where is the crankshaft position sensor on a 2004 Trailblazer?

If your 2994 Chevrolet Trailblazer has a 6cyl engine the crankshaft position sensor is located on the left side of the engine toward the rear just above the oil pan. On a V8 the sensor is located in the lower part of the timing cover.