What should the low fuel feed be set on?
Low Fuel Feed of 1 is the correct setting , do not set that up to 6 it will run too many pellets.
What settings should my pellet stove be on?
It is best to run the appliance on the lower heat settings like 2 or 3 rather than up at 4 or 5. The higher heat settings result in lower efficiency and the appliance cycling from high to pilot fire too often.
What is low burn air on pellet stove?
essentially the low fuel feed controls the fuel feed on the lowest heat ranges (1 and 2 ) and the low burn air controls the speed of the combustion blower at the same low ranges. so in essence the low fuel feed determines how many pellets per “dose” are fed.
What does 5u mean on a pellet stove?
This is normal and indicates that the stove is in Start Up mode. If proof of fire is not made by the end of that period the stove automatically shuts down.
What are the correct settings on a New England pellet stove?
These buttons control how the pellet stoves operates. The factory settings are 6 on the LFF, 4 on the LBA and 1 on the AOT. If for some reason these setting are out of adjustment they can be readjusted back to the factory settings.
How do I increase the airflow in my pellet stove?
Pull out on the handle or rod slowly if you have a tall, slow burning flame. Pulling the handle out from the stove increases the amount of air inside the stove. Continue to pull out on the handle until you’re satisfied with the amount of air inside the stove, and the flames burn normally.
How do I adjust the feed rate on my pellet stove?
On Original Energy stoves, to allow more pellets into the firepot on each feed, increase the feed rate by loosening the thumb screw on the feed rate adjustment rod inside the hopper. Raise the rod only about ¼” with each adjustment, and retighten the thumbscrew each time.
What does the feed rate mean on a pellet stove?
The feed adjuster on a Harmon pellet stove determines the feed rate of the pellets into the combustion chamber of the stove. If the feed rate is set too high, partially burned pellets will be pushed off the end of the burn pot, wasting fuel. If the feed rate is set too low, the stove will not generate enough heat.
How do you adjust a pellet stove?
How to Adjust the Air Intake for a Pellet Stove
- Observe the flames inside your wood pellet stove.
- Look for the damper handle or damper rod on your stove.
- Push in on the handle or rod slowly if you have a quick burning, short flame.
- Pull out on the handle or rod slowly if you have a tall, slow burning flame.
Why would a pellet stove stop feeding pellets?
If your Harman Stove has stopped feeding pellets, there could be a few simple solutions: The front door, ash pan door or hopper lid may not be closed properly. Fill the hopper and allow a few minutes for the unit to auger the pellets onto the burn pot. Venting may be blocked.
What is the pu-cb04 control panel used for?
This Digital System Control Panel & Circuit Board Board PU-CB04 for newer Englander pellet stoves is used for adjusting the heat level to make it a higher or lower setting.
How does the Englander pellet stove control board work?
Englander pellet stoves are efficient heating units. The control board comes with preset factory settings. On the control board there are three buttons on the bottom. The first button is the “Lower Fuel Feed” (LFF), second is the “Low Burn Air” (LBA) and the third is “Air On Temp” (AOT). These buttons control how the pellet stoves operates.
What are the buttons on the pellet stove control board?
The control board comes with preset factory settings. On the control board there are three buttons on the bottom. The first button is the “Lower Fuel Feed” (LFF), second is the “Low Burn Air” (LBA) and the third is “Air On Temp” (AOT). These buttons control how the pellet stoves operates.
