What is automatic level control system?

Abstract: Automatic Level Control (ALC) is a technology that automatically controls output power to the speaker. ALC prevents loudspeaker overload and optimizes dynamic range. It protects the loudspeaker by limiting the amplifier output power. It boosts low-level signals without distorting the high-level signals.

What is auto load leveling?

From Wikipedia, the free encyclopedia. Self-levelling refers to an automobile suspension system that maintains a constant ride height of the vehicle above the road, regardless of load.

What is electronic level control?

An electronic water level controller’s , also known as an electronic tank level controller switch, main function is to automatically control the water level inside a tank. Most electronic water level controllers use rods or sensors to check the water level to see if it is too high or too low.

What is automatic air suspension system?

INTRODUCTION ’The automatic air suspension system is an air-operated, microprocessor controlled suspension system. This system replaces the conventional coil spring suspension and provides automatic front and rear load leveling.

How does a level control system work?

In level-control systems, fluid flow rates are controlled by varying the degree of opening of a gate-type valve. Because of the forces involved, a pneumatic ‘actuator’ is normally employed, working off a controlled pressure in the range between 3-15 pounds per square inch (i.e. psi).

What is the purpose of a load leveler?

A method for reducing the large fluctuations that occur in electricity demand, for example by storing excess electricity during periods of low demand for use during periods of high demand. A height adjustable, self-aligning rubber foot eases load leveling.

How does a load leveling system work?

How It Works. A weight distribution hitch (aka “load equalizing hitch”) does just what the name says — it is a hitch that evenly distributes the weight of your payload. It works by using adjustable spring bars and tension to distribute the load of the trailer tongue to the trailer and vehicle axles.

How does a water level sensor work?

Water level indicators work by using sensor probes to indicate water levels in a storage tank. These probes send information back to the control panel to trigger an alarm or indicator. As mentioned above, the control panel can be programmed to automatically turn on your pump to refill the water again.

What is the ELC fuse?

ELC = Electronic Level Control. He probably pulled the fuse because of a bad compressor, exhaust valve or leaking shock or line that cause the ELC compressor to run continiously.

Where is the fuse for the level control compressor?

Manual doesn’t specify which fuse runs the compressor. My car has 120000 miles. My car has an automatic transmission. The fuse for the level control compressor is located in the under the hood fuse block. It is a 40 amp fuse number 61. There is also a relay between this fuse and the electronic suspension control module.

What does electronic level control ( ELC ) stand for?

In some literature, Computer Command Ride/Real Time Damping (CCR/RTD) system may be referred to as simply CCR or RTD. DESCRIPTION. The Electronic Level Control (ELC) system automatically raises or lowers rear of vehicle to correct ride height (curb height), compensating for loads added to or removed from vehicle.

How does a GM Autoride air suspension compressor work?

The compressor is a positive displacement piston air pump. It draws filtered air through an intake line attached to an underbody rail. The compressed air is then run through a dryer containing a moisture-absorbing chemical that dries the compressed air before it is sent to the shock absorber chambers.

Is there an automatic leveling system on smartair 2?

The Perfect Ride, All the Time. Maintain the perfect ride height, automatically, no questions asked. Note: SmartAir II fits leaf sprung vehicles only. Automatic Leveling System.