What is a termination bar in roofing?

Termination bars are strong metal strips that are designed to support a roofing membrane system at it’s termination point on a vertical surface.

What is termination bar used for?

TERMINATION BAR is a multi-purpose, preformed, professional way to attach a wide variety of construction waterproofing, drainage boards, and flashing systems. TERMINATION BAR is a high strength, plastic strip designed to support vertical membrane systems at their termination point.

How does a termination bar work?

Termination bar is used to secure and seal single-ply membranes at parapet walls and other penetrations. Usually made of extruded aluminum – 1/8 inch thick and 1 inch tall with pre-punched holes for fastening – term bar is sold in 10-foot-long sticks. The bar is placed at the top of the flashing and fastened in place.

Can you put EPDM over felt?

However, for surfaces such as felt, overboarding and adding an EPDM rubber roof is ideal for adding protection to it and further insulating your roof….Asphalt flat roof construction, repair and replacement with an EPDM Rubber Roofing Membrane.

What is the best adhesive for EPDM?

Which industrial adhesive can be used to bond EPDM rubber? Cyanoacrylate adhesive is practically the only choice if you are looking for a high strength bond. Permabond recommends its 105 grade cyanoacrylate for this troublesome substrate.

Can you overlap EPDM?

Overlap the two rubber membranes by 75mm (3inches) Overlap the two rubber membrane sheets to be joined by 75mm (3inches). It is common on long runs to overlap the two sheets by more than 3″ and then cut back the top sheet of rubber membrane once the splice tape has been stuck to the bottom sheet.

What is a masonry termination bar?

Termination bars are used to secure flashing to a backup wall. Start fastening at one end of the bar and proceed to the next hole to avoid bowing. Apply a sealant to the top edge of the bar and feather. Standard/Special. Standard.

Can you lay shingles over EPDM?

An EPDM rubber roof can be bonded to asphalt but this depends on the rubber membrane system you are using. It cannot be bonded to uneven surfaces such as shingles as this hinders the membrane from successfully bonding onto the surface.

Can you stick EPDM to Fibreglass?

ClassicBond EPDM is best bonded on to timber surfaces such as roofing grade plywood or OSB3 (Oriented Strand Board) sometimes called sterling board. ClassicBond can also be bonded to light weight concrete and other non porous surfaces such as Fibreglass and tissue faced insulation.

What sealant can I use on EPDM?

Lap Sealant

• Firestone Lap Sealant is a high quality sealant with excellent adhesion to a variety of surfaces, and for use in conjunction with Firestone EPDM systems.
• Surfaces to receive Lap Sealant must be clean, dry and free from loose and foreign materials, oil and grease.