Is there a fuse for the dashboard lights?

Find the fuse that powers your dashboard lights. Check under the hood, under the dashboard, or near or in the glove compartment. Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse. If you have more than one fuse labeled “lights,” you’ll need to check them all.

What does it mean when your dashboard lights go out?

If the dashboard isn’t lighting up at all, your car might have blown a fuse. Removing the old fuse and replacing it should get the lights working again. While the new fuse may do the trick, it could also indicate a deeper electrical problem.

Is there a fuse for dash gauges?

When all of the gauges or warning lights in your car stop working at once, the problem is something that all of the gauges and lights share in common. Check the fuses first. The fuse may be labeled gauges, cluster, or something similar. This fuse should have power on both sides with the ignition in the on position.

Where is the fuse for the dash?

The interior fuse box is underneath the dashboard on the driver’s side. There are two under-hood fuse boxes in the engine compartment. The main fuse box is located on the passenger’s side near the battery.

Where is the fuse for the dashboard located?

Fixing Dashboard Lights: Finding a Blown Fuse The instrument panel fuse box is usually located inside the vehicle, and usually on the driver’s side. There should be a diagram inside the fuse box (or in the owner’s manual) that shows you what each fuse powers.

How do I turn on the lights on my jeep dashboard?

Rotate the center portion of the lever upward to the next detent position to brighten the odometer and radio when the parking lights or headlights are on. Rotate the center portion of the lever upward to the last detent to turn on the interior lighting.

Why wont my interior lights turn off in my Jeep?

If the interior lights on your Jeep Liberty stay on, there could be three possible issues: the fuse is stuck, one of your doors is open, or the light switch is set to the “ON” position. All three of these issues have very simple solutions that should not take more than ten minutes to solve.

What do you do when your dashboard lights go out?

If your dashboard lights aren’t working, find the fuse associated with your dashboard lights and check inside. If the fuse has blown, replacing it may be all you need to do to fix the problem.

Why are my dash lights and tail lights not working?

It could be that the dash and taillights share a common fuse. So, if you do find a blown fuse, you’ll need to track down the reason it blew in the first place. Other potential causes for your problem include a short somewhere in the circuit or a faulty light switch.

Where are the fuses for the dashboard lights?

Find the fuse that powers your dashboard lights. The location of the fuse box can vary between vehicles and some have more than one fuse box. Check under the hood, under the dashboard, or near or in the glove compartment.

Where are the fuses on a Jeep Wrangler?

The cluster info in on about page 92, interior lighting p 120, front lighting p 135, rear lighting p 140. The other section you might need is the connector location section (separate selection). OK now pull fuse 12 from the fuse block & see if the short goes away.

Where are the lights on a Jeep Wrangler?

The relay is controlled from the ignition switch & fuse 3, PDC. If you don’t have a manual with wiring diagrams go here to View them. For ’97TJ go to the wiring section. The cluster info in on about page 92, interior lighting p 120, front lighting p 135, rear lighting p 140.

Is there a fuse for the rear lights?

Yes fuse 1 its a 20amp fuse. I disconnected the plug for the rear lights under the dash and the front lights at the plug near the firewall under the brake master cylinder. Yes fuse 1 its a 20amp fuse.