Is Alto a good speaker brand?
Alto Professional is known for offering good quality speakers at affordable price points.
What is contour Alto speaker?
There are two switches on the rear for controlling ground lift and ‘contour’, the latter boosting the low and high frequencies by a few dB. Contour is especially effective when the speaker is operating at low volumes or playing back pre-recorded audio. Note the increased high- and low-frequency output of contour mode.
What is a 2 way speaker?
A two-way speaker is one that has two drivers in each container or each box, in this case, it would be a tweeter and a woofer most of the time a two-way the woofer will act as a second between the mid-range and the Tweeter wherever the Roloff Falls between the two and a 3-way system you would have a tweeter a small one …
Are Carvin speakers good?
Excellent speakers. The first version was a bit lighter using neodymium magnet woofers. These sound just as good but are a few pounds heavier – but still light enough to carry one in each hand. They are unpowered but matched with one of carvin’s mixers they sound great.
Where is alto speakers made?
Alto products made in China.
What is alto in music?
alto, (Italian: “high”), in vocal music the register approximately between the F below middle C to the second D above—the second highest part in four-part music. The word alto originally referred to the highest male voice, singing falsetto (see countertenor).
What is mix out on speaker?
“Speaker Out” jacks on your mixer suggest you are trying to connect outputs from a powered mixer or power amp to your unpowered (or passive) speakers. Almost all current mixers have balanced output jacks, again with XLR, TRS, or both connectors. It’s possible (though rare) that your mixer only has unbalanced outputs.
Can you connect two active speakers?
The easiest and more effective way is to connect two powered speakers to the Main Out. One to the left and one to the right output of the mixer, then daisy chain the other two speakers. Another way is to connect two speakers to the Main Out, and then connect two more to the SUB OUT channel, also called GROUP OUT.
Where are the mics on the Alto ts115a?
The TS115A’s built-in mixer gives you an added level of versatility and convenience. Two Mic/Line combo inputs are located on the back of the speaker, so you can plug microphones and instruments in directly and find the perfect blend via two independent volume controls.
What kind of RMS does Alto truesonic ts115a have?
The active part of the TS115A consists of a simple two-channel line-input mixer feeding a power amplifier. This amp is capable of providing 400W RMS (335W RMS for the LF amp and 65W RMS for the HF side) or an 800W peak, as proclaimed by a big peel-off sticker on the front.
Can a ts115a be used as a floor monitor?
The TS115A is designed to be a ‘fit for all’ unit, and can be used upright as a main PA speaker or on its side as a floor monitor. It can also be used as a fixed installation unit, as there are six integrated M10 rigging points for flying it above ground.
How big is an alto truesonic portable speaker?
Alto’s Truesonic portable full-range speakers are just such advanced models, and the range includes both 12-inch and 15-inch two-way formats, each of which is available in a choice of three models.
