Is a Dana 60 kingpin stronger than a ball joint?

Yes, a kingpin is and always be strong than a ball joint, mainly because a ball joint just has a large crimp holding it all together. Do you need it? The Dana 60 Lower ball joint is a lot larger than a Dana 44 ball joint (the upper, not so much).

Which is better kingpin or ball joints?

Kingpin knuckles are generally stronger, easier to maintain, and more durable than balljoint knuckles. Also, if you break an axle, the broken chunks can pop out the ball joints in a balljoint knuckle–kingpins can’t be popped out like that.

Is a king pin the same as a ball joint?

A ball joint is a metal case that is crimped around a ball that has a threaded shaft protruding from it, while a kingpin is a solid pin that either a bushing or bearing rotates around.

What year is a Dana 60 kingpin?

The King Pin Model 60 stayed in the Ford lineup as the only available front drive axle for the F-350 until the end of the 1991 model year. Ford switched to a ball joint Model 60 for the 1992 model year.

What is kingpin axle?

The steer axle kingpin is the pivot point between the axle beam and the wheel ends. It is also the point of connection for the spindle knuckle, the wheel ends, and the steer axle.

Are all Dana 60 high pinion?

The easy ID for these is that they use a low pinion arrangement, while all Ford D60’s ‘77.5 and newer are high pinion (van conversions are the rare exception).

Is a Dana 60 a one ton axle?

One thing that’s confusing about the Dana 60 axles is that a Dana 60 in front is usually considered a 1 ton axle, and a Dana 60 in the rear is usually considered a 3/4 ton axle. This is most likely because the rear axle in a truck carries more weight than the front (when loaded).

What is the purpose of a kingpin?

The kingpin (also king-pin, king pin and k pin) is the main pivot in the steering mechanism of a car or other vehicle. The term is also used to refer to part of a fifth wheel coupling apparatus for a semi and its trailer or other load.

How much torque can a Dana 60 take?

Torque specs for the Dana 60 are 120 ft/lbs.

How strong is a Dana 60 rear end?

Dana 60 rear axle The semi float axles have GAWR up to 5,500 lbs and the full float axles were rated up to 6,500 lbs. Full floating variants are common while Semi-floating axles exist, but are less common. Axle spline count varies, with 30 spline being the most common.