How do you put lead in a Tul pencil?
Instructions
- Remove the eraser located at the top of the mechanical pencil. Grip the eraser and pull it straight up and place it to the side.
- Hold the pencil upside down to remove the old lead. Shake gently to remove any unseen debris.
- Remove the lead refill from its package.
- Replace the eraser.
Are Tul pencils refillable?
For use with TUL Mechanical Pencils. TO REPLACE REFILLS: 1. Pull off top cap that holds the eraser….TUL® Lead Refills, 0.7 mm, HB Hardness, 30 Leads Per Tube, Pack Of 3 Tubes.
| Item # | 4726426 |
|---|---|
| Product Type | Mechanical Pencil Refill |
How do you put lead in a Kuru Toga pencil?
- Pull off the cap.
- Pull out the eraser.
- The lead magazine is underneath. The Kuru Toga leaves only a hole by which to access it; others usually have it more open. Either way, this is where you put lead in.
- Put the eraser back in.
- Put the cap back on. Done.
How do you replace the lead in a mechanical pencil?
Press and hold the button while tapping the mechanical pencil in an upright position. (This allows any lead particles to fall out.) Gently insert the new pencil lead refill into the shaft, and then release the button. Click it repeatedly until your newly replaced lead is in the correct position.
How do you change the lead in a Tul mechanical pencil?
Remove the eraser located at the top of the mechanical pencil. Grip the eraser and pull it straight up and place it to the side. Removing the eraser will expose a chamber where the lead for the pencil is located. Hold the pencil upside down to remove the old lead.
How do you attach led to a mechanical pencil?
How do you refill BIC lead pencils?
To refill a BIC mechanical pencil please follow these steps: (1) remove the eraser, (2) insert new leads, (3) replace eraser & (4) click eraser to advance new lead.
