How do you fix an F28 error on a Whirlpool washer?
An F28 error code is a common problem that means there is a communication problem with the central control unit. This problem is generally solved by essentially rebooting the control unit. Rebooting the control unit is accomplished in less than 10 minutes, even by the novice.
What does the code F28 mean on a Whirlpool washer?
F28 means that your main central control board (CCU) and the motor control board (MCU) are not communicating with one another properly. You will need to check all the connections at both boards, the mcu is in the bottom of the washer and the ccu is mounted at the top inside of the washer on the right side.
How do I reset my whirlpool error code?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
How do I fix the error on my Whirlpool washing machine?
An LE error code on the washer’s display indicates that the motor is locked, possibly due to a heavy wash load. Large and heavy sized loads will put a strain on the motor, causing the LE code to occur. Performing a reset on the washer will normally resolve this error with a reduced load size.
What does the code F28 mean?
ignition fault
The F28 code is displayed when your boiler fails three ignition attempts, resulting in the boiler halting operation and turning off. Vaillant officially defines the F28 error code as an ignition fault. Therefore, the causes of the F28 fault can be broadly categorised into either an ignition fault or a gas valve fault.
What does the code F21 mean on a Whirlpool washer?
If your Whirlpool washer is showing an F21 error code, this means that your washer is unable to drain properly. This can be caused by a clogged pipe, a faulty drain pump, or something simpler.
What does F24 mean on Whirlpool washer?
water temperature sensor error
The “F24” fault code indicates a water temperature sensor error. The temperature sensor could be faulty; the wire connection may have vibrated loose or off the sensor or a possible heater or control board failure.
Does a Whirlpool washer have a reset button?
How to Confirm You Have Reset Your Whirlpool Washing Machine. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
How do I reset my Whirlpool washing machine?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
What does F28 mean on a Vaillant?
The F28 fault code will be displayed on Vaillant EcoTec boilers when 3 ignition attempts have been unsuccessful. At this stage your boiler will lockout. In order to get your boiler up and running again, a Gas Safe engineer will need to rectify the problem, and then go through the reset procedure.
