How do I troubleshoot my GE washing machine?
How to Troubleshoot a GE Top Load Washer
- Check the amount of detergent you have put in the washer.
- Examine the GE top load washer’s drain hose for leaks.
- Check the water connections to your GE top load washer.
- Check whether the GE top load washer lid is closing firmly.
- Check the load in your GE top loading washer.
How do I reset my GE front load washer?
Plug the washing machine back in and then within 30 seconds, quickly open and close the lid six times. You’ll need to do this within a 12-second period. Raise the lid at least 2 inches and make sure it closes each time. This should complete the motor reset.
How do I check the error code on my GE front load washer?
To enter the error code test mode on a GE front load washer, rotate the control knob until t02 is displayed in the control panel then press start/pause to enter the test mode. This is where all error codes are stored.
How do I reset my GE washer?
Unplug the washer for one minute, then plug the washer back into the electrical outlet and lift and lower the lid six times within 12 seconds. This will reset the motor and you should be able to start the cycle.
Why is my GE washer not working?
Causes. When a GE washer stops working, it could be because of a broken spin belt, a blown fuse, a melted wire, a backed-up water pipe, or a burnt-out power outlet. The most straightforward reason your GE washer isn’t working anymore is that it’s not plugged into a reliable power source.
Does a GE washer have a reset button?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
How do you troubleshoot a GE front load washer?
How to Troubleshoot a GE Front Load Washer That Won’t Spin or…
- Remove any kinks in the drain hose.
- Inspect the household drain.
- Check the drain and make sure there is an air gap between the hose and drain.
- Clean the pump filter.
- Rearrange the clothing in the load.
- Allow the washer to cool down for two hours.
How do you reset the code on a GE washing machine?
How to Access Error Codes on GE Washers
- Press the “Power” button on your GE washer.
- Unplug the power cord for at least 30 seconds.
- Plug the power cord back in to the GE washer.
- Press “Delay Start” to advance to “t02”.
- Press and hold “Start/Pause” to clear the saved error codes after viewing them.
How do I get my GE washer out of diagnosis mode?
Step 7. Press “Signal,” press “Delay Start,” press “Signal,” and press “Delay Start” to exit the test mode of your GE washer.
Why won’t my GE washer drain and spin?
Make sure the drain hose is properly connected and that there are no kinks or pinched areas. Your washer may not drain and enter the spin cycle if the pump filter is clogged. A clogged household drain can also cause water to stand in the washer and prevent the spin cycle from starting.
