How do I reset my Minn Kota remote?

The easiest way to reset your Minn Kota remote is simply to turn it off and back on again. Wait a few seconds before attempting to pair it with your trolling motor again.

How do I reset my i Pilot remote?

Remove power from the receiver by unplugging the receiver from the motor. 2. Press and hold the LEARN button and power up the receiver by plugging it back into the motor. Hold the learn button down for 10 seconds.

How do you unlock the Minn Kota remote?

Pressing and holding the Screen Navigation button also locks and unlocks the remote. Press the Cruise Control button to enable or disable Cruise Control. Once Cruise Control is enabled, pressing the Speed Up or Speed Down buttons will change the Target Speed rather than the Prop Speed.

How do I update my i Pilot remote?

TO UPDATE VIA THE MOBILE APP:

  1. Download the i-Pilot app for iOS or i-Pilot app for Android.
  2. Open the i-Pilot application from the device.
  3. If the Application Update Indicator icon is present, select it.
  4. An Update Software screen will appear.
  5. Follow the on-screen prompts to successfully complete the update.

Is there a reset button on a Minn Kota trolling motor?

Press and hold the POWER button until the power is off. The green LED will turn off. Red and Green LED lights will flash and the motor will automatically reset itself.

How do I pair my phone to my Minn Kota trolling motor?

Pairing the mobile device to the trolling motor is easy After downloading the Minn Kota i-Pilot or iPilot Link app to an iOS or Android device, an angler then “pairs” it with a Bluetooth-enabled Minn Kota trolling motor. The push-button task is fast and simple.

What is the Learn button on the Ipilot remote?

Push and hold the learn button down (learn button is located at the top of the remote). A steady audio tone will be heard while holding this button. While holding the learn button on the controller, push any button on the remote. Three short chirps will be heard when the remote is successfully learned.

How much does it cost to replace a Minn Kota remote?

A new i-Pilot remote usually resolves the problem, which Minn Kota will replace under warranty. Sometimes a malfunctioning Spot-Lock requires a head control unit replacement and/or new sensors. If you’re out of warranty, they will cost you a few hundred dollars.

How do I power up Minn Kota motor?

Power up the trolling motor. 2. Push and hold the learn button down. A steady audio tone will be heard while holding this button. 3. While continuing to hold the learn button on the Motor Control Head, from the remote home screen select: Controls > Learn and press the OK key 4.

Is there a problem with my Minnkota remote?

A PIA. Took the motor and remote to the warranty center and they could not get it to replicate problem. MinnKota again replace the remote. A few trips into last spring same problems. Shipped the unit to MinnKota in Mankato and they replaced the head. Now same damn problem.

Are there any problems with the Minn Kota?

Minn Kota tries hard to make stowing and deploying their motors as easy as possible. The Terrova uses a spring-loaded lift assist mechanism, which can cause it to bounce in and out of water. Another problem that repeats with the Terrova and other electric-steer models, is the motor shutting down when you go the full speed.