How do I reset my Dlink router to factory default?

How do I reset my router to factory default settings?

  1. Step 1: With the router on, insert the end of a paper clip into the pinhole highlighted below.
  2. Step 2: Hold the paper clip down for 10 seconds and release.
  3. Step 3: The unit will reboot automatically. Once the WLAN light stops blinking, the unit has been reset.
  4. Note:

How do I reset my Dlink DIR-615 router password?

DIR-615 Default Password Doesn’t Work?

  1. Plug in the router and turn it around where all the cables are connected.
  2. Use a paperclip or other small object to hold down the Reset button for 30 seconds.
  3. Wait for 30 to 60 seconds while the router finishes booting up.

How do I reset my router to default settings?

How to Reset Router From Configuration Page

  1. Type your router’s IP address into any web browser’s search field.
  2. Enter your username and password when prompted.
  3. Go to System or System Tools.
  4. Look for Restore or Factory Default.
  5. Click Restore or Reset and OK to confirm.
  6. Wait for the router to reboot.

How do I reset my Dlink DIR 600m?

Locate the reset pin hole on the back of the DIR-600 as per below: 2. Insert a paperclip into the reset pin hole and hold in for 10 seconds. While holding in the reset button, refer to the Power LED, when it turns yellow/orange, release the paperclip holding in the reset button.

How do I reset my Dlink DIR 605L?

To reset the D-Link DIR-605L to its default settings, you have to do the following steps:

  1. Turn on router.
  2. Press RESET button for at least 10 seconds.
  3. Device is automatically restarted.
  4. Restoration of standard settings is finished.

What is Dlink default password?

The default user name for the D-Link DI-624 wireless router is “admin,” and the Password field should be left blank.

How do I reset my Wi-Fi settings?

How to reset network settings on an Android device

  1. Open the Settings app on your Android.
  2. Scroll to and tap either “General management” or “System,” depending on what device you have.
  3. Tap either “Reset” or “Reset options.”
  4. Tap the words “Reset network settings.”

Does a D-Link DIR-615 have a WPS button?

The WPS button located on the right side panel of the router is designed to quickly add wireless devices to the router’s WLAN. A separate LED is located on the WPS button.

How do I update my Dlink 615 firmware?

How to update firmware for DIR-615

  1. Step 1: Open a web browser and enter http://192.168.0.1 on the address bar.
  2. Step 2: Enter your Admin Password in the field provided.
  3. Step 3: Click on Tools Tab then click on Firmware on the left hand side.
  4. Step 4: Under Firmware Upgrade, Click on Browse button to locate the file.