How do I remove snap on KMC link?

Re: Removing a snap-on chain link It isn’t a SRAM Powerlink thingamajig, simply a snap-on link. If it’s open one end then you can push it off with a screwdriver. If it’s one you bend the chain to slip on then you need to bend the chain slightly (be careful) to compress the pins so you can slip it off.

How do you release a chain link?

To disconnect this type of link, place one jaw of your pliers on the chain pin, and the other jaw on the open end of the clip. Then squeeze your pliers until the clip pops off. Then you can remove the outer plate and slide out the rest of the link.

Do all KMC chains have a missing link?

Yes, KMC constructs Missing Link I, II, 9, and 10 for 7.3mm, 7.1mm, 6.6mm, and 5.9mm respectively; all Missing Links are compatible with Sram, Shimano, and Campy equivalent chains. Our chains also feature our XXSP stretch proof treatment. This is a treatment that we have perfected in our years of chain manufacturing.

Can I reuse a KMC Missing Link?

Yes, a regular chain tool can be used to shorten KMC Chains and no special tool is needed. All other Missing Links can be reused between 2-3 times per life cycle of the chain. If you purchase a replacement chain, the used Missing Link should not be reused and is not interchangeable.

Is the KMC 11 speed chain reusable or re-useable?

In the case of KMC’s 11-speed links, the non-reusable link (pictured left) has a small identifying groove that sits inline with the slot, while the re-useable model (right) is without such a groove. A little-known fact is that KMC offers both reusable and non-reusable quick links for 10 and 11-speed chains.

Are there any reusable quick links from KMC?

A little-known fact is that KMC offers both reusable and non-reusable quick links for 10 and 11-speed chains. The packaging will detail which is which, or otherwise, a close look at the link itself will tell you what you’re dealing with. Annoyingly, most sellers of these links don’t specify what they’re selling.

How do you remove a quick link on a chain?

If you plan on replacing the chain and don’t have the tools to undo the link, you can use a chain breaker on any chain pin other than the master link to remove the chain. When using the appropriate tool, simply insert the tool into the nearest rollers and squeeze the handles. This will pull the link together and undo the quick link.

What’s the proper way to use a chain link?

Ensure chain link is centered above the chainstay, firmly apply rear brake and stand on drive side pedal. Push down until the link seats. Note: Wippermann has a unique re-usable “Connex” link that does not require any force to close. See our video above or Wippermann’s instructions for correct use.