How do I get to RAID configuration on HP ProLiant?

Procedure

  1. Start or restart the HP server.
  2. At boot time, press F8 to enter the Integrated Lights-Out 2 setup.
  3. Provide credentials at the login prompt.
  4. Press Ctrl+S to open the Intel Boot Agent Setup Menu.
  5. Press F8 to open the ROM Array Configuration menu.
  6. From the Main Menu, select Create Logical Drive and press Enter.

How do I get to HP Array Configuration Utility?

Open the browser on the remote server. The System Management Home Page opens. 3. Click Array Configuration Utility on the left-hand side of the screen.

How do I access bios on HP ProLiant dl180g6?

BIOS configuration. Turn on or restart the machine, and type F10 when appropriate to access the BIOS setup screen. Press the right arrow to get to the Advanced tab, scroll down to IPMI Configuration , and press the Enter key.

How do I disable RAID in HP ProLiant?

To disable the controller follow the steps listed below: Press F9 during POST to enter “System Utilities” then select System Configuration > BIOS /Platform Configuration (RBSU) > PCI Device Enable/Disable > Embedded SATA Controller #1 : Dynamic Smart Array B140i 8 port > Press Enter, and select disable.

How do I check my HP RAID configuration?

You can also reboot and view the array configuration from the BIOS utility or by launching the F10 Intelligent Provisioning menu. If you have access to the server’s ILO4 interface, you can get the array configuration from that by clicking on the “Storage” menu.

How do I access HP Smart Array?

During the initial boot:

  1. To modify the server configuration ROM default settings, press the F9 key in the ProLiant POSTscreen to enter the UEFI System Utilities screen.
  2. If you do not need to modify the server configuration and are ready to install the system software,press the F10 key to access Intelligent Provisioning.

How do I check my BIOS version HP ProLiant?

Version state: final FIX: The BIOS and iLO firmware versions can be determined from the command line by using the dmidecode command to retrieve BIOS information. For example: # dmidecode -t bios # dmidecode 2.11 SMBIOS 2.7 present.

How do I find my RAID server settings?

How to Guide: Checking if a RAID is configured

  1. Rick click on the “computer” icon on the desktop.
  2. Select Manage.
  3. Expand Storage.
  4. Click Disk Management.
  5. In the bottom center pane you’ll see different Disk numbers.
  6. Under the Disk number you’ll see either Basic or Dynamic.

How many drives does the HP ProLiant dl180 G6 have?

HP Proliant DL180 G6 RAID Configuration. Currently have a HP Proliant dl180 g6 server with 6 2TB drives. Configured the server for RAID 5. In the controller it shows 5 Drives in the RAID 5 and one hot spare.

Is the HP smartarray p212 A RAID controller?

I have a HP ProLiant DL180 G6 with HP SmartArray P212 raid controller. RAID controller doesn’t show up in BIOS boot menu. On booting up there is no message like “Press F8 to enter HP SmartArray P212 array configuration”

What kind of processor does HP ProLiant G6 have?

Processors: Supports up to two Quad-Core Intel® Xeon® processors: 5500 sequence with 8MB Level 3 cache Intel® 5520 Chipset Memory: Up to 96GB, using PC3-8500R DDR3Registered (RDIMM) memory, operating at 1066MHz when fully populated at 2 DIMMs per Channel in 12 slots.