How do I fix error code P1259?
The most common cause for Error Code P1259 or VTEC system malfunction is low oil pressure. Thus, make sure you check your oil if it’s due for service. Change oil and filter if necessary. Clear the codes and then give it a try.
What are the symptoms of a bad VTEC solenoid?
Here are a few symptoms of a worn out or broken VVT solenoid.
- Check Engine Light comes on. Since today’s modern cars are controlled by an Engine Control Unit (ECU), virtually all individual components are monitored by the ECU.
- Engine oil is dirty.
- Rough engine idle.
- Decrease in fuel economy.
Why does my VTEC solenoid keep going out?
The fact the solenoid continuously fails may indicate that electrical side or mechanical side behind it is not working properly. These assemblies can clog and cause issues with the solenoid. You can replace or clean the assembly if needed. If the assembly is fine, you will want to turn to electrical testing.
Where is oil pressure switch?
engine block
The oil pressure switch is usually located on the engine block, often near the oil filter, and warns the driver whenever the oil pressure gets too low by illuminating a red oil light in the instrument cluster. Some vehicles use an oil pressure gauge in place of, or in addition to, a red oil light.
What happens if you drive with a bad VTEC solenoid?
If the VVT solenoid fails or is blocked, the lack of proper lubrication can cause the timing chain and gear to prematurely wear or break entirely.
How much does it cost to replace a VTEC solenoid?
The average cost for a Variable Valve Timing Control Solenoid Replacement is between $198 and $253 but can vary from car to car.
How much is a VTEC solenoid?
Used honda element vtec solenoid replacement sold eBay prices are $138. New current listings averaged $-37 lower vs used current listings for a difference of -45.68%. On Amazon, the average price is: $30 for the first 10 product results.
What does code p1259 mean on a Honda?
As stated elsewhere, code P1259 refers to an electrical issue in the VTEC control system, and all diagnostic procedures for this code should start with a thorough visual inspection of all associated wiring and connectors. Nonetheless, some other common causes of code P1259 could include the following-
Where is the p1259 sensor located on a Honda Civic?
It should be noted though while that code P1259 specifically refers to a problem in the VTEC systems’ control/signal/monitoring circuit, some mechanical failure modes can contribute to this code being set and stored. Where is the P1259 sensor located? The image above shows the location of the VTEC oil control solenoid on a Honda Civic engine.
What is the trouble code for Honda VTEC?
P1259 – VTEC system malfunction (Honda) Trouble Code Fault Location Probable Cause P1259 VTEC system malfunction Wiring, VTEC solenoid/pressure switch, E
What is the OBD 2 fault code for Honda?
OBD II fault code P1259 is a manufacturer specific code that is defined by carmaker Honda as “VTEC System Circuit Fault (Bank 1)”, and is set on these applications when the PCM (Powertrain Control Module) detects a defect, malfunction, or failure in the electrical control/monitoring system of the VTEC mechanism on Bank 1.
