How do I attach a towel rack to a wall?

Insert wall plugs into holes. To prevent cracking around the edge of the tile, use an old screw to screw in the plug then use a hammer to tap the wall plug below the surface of the tile. Remove screw. Using the screws and plate supplied with the towel rail, firmly affix rail to wall.

How do you secure a towel rack to drywall?

Attach the first towel-bar mount. Screw the bar’s mounting plate (in this case a plastic bracket) into the anchor. The toggle will automatically swivel into position behind the drywall as the screw is driven in. Continue turning the screw until the toggle snugs up against the back side of the drywall.

How do you attach a towel rack to a wall without drilling?

Here’s how to do it.

  1. Measure and mark the walls where you want the towel bar to go.
  2. Apply a small bead of glue to the back of the towel rack or mounting brackets and press firmly into place.
  3. Quickly clean up any glue that has seeped out around the edges.
  4. Allow for full cure time before hanging weight on the bar.

How do you fix a towel rack?

Loosen the set screws under the towel bar and remove it from the wall. Loosen the bracket screws and remove the brackets from the wall. Insert toggle bolts in each bracket. If needed, enlarge the bracket holes in the drywall with a screwdriver, and insert the toggle bolts in the holes.

How do you install drywall anchors?

How To: Use Drywall Anchors

  1. STEP 1: Choose the right drywall anchor.
  2. STEP 2: Twist the self-drilling wall anchor into drywall with moderate pressure.
  3. STEP 3: Turn the drywall anchor in until the lip is flush with the wall.
  4. STEP 4: Attach your rack or shelf to the wall by screwing into the drywall anchor.

How do you hang a towel bar on a tile wall?

Method 2 – Drilling into the Tile

  1. Step 1 – Determine Location. Use a stud finder to locate studs on the wall, and determine if you will be able to attach the towel rack on the studs based on its length.
  2. Step 2 – Level the Rack.
  3. Step 3 – Drill Holes for the Supports.
  4. Step 4 – Wall Anchors.
  5. Step 5 – Install Holder.