How do I enter WPS pin on Virgin router?

How do I use a PIN to add a WPS client to my Virgin Media Hub?

  1. Access the settings page by entering the web address shown on the Hub sticker.
  2. Click Advanced settings from the menu on the left.
  3. Click on Wireless then WPS.
  4. Tick the Enable option next to WPS PIN.
  5. Under the Add WPS client tick the option next to PIN.

How do I activate my Virgin Media Hub?

Press the power button on and the Hub will start to boot up. For Hub 4 this may take around 5-10 minutes the first time as the Hub needs to update its software. At the end of the boot up sequence, the light ring will be resting on solid white. Now you are ready to connect your devices.

What is the IP address of my virgin router?

*Enter If you have enabled Modem Mode on the Hub you will need to use 192.168. 100.1 instead. When prompted, enter the settings password shown on the bottom of the Hub.

Where is the WPS button on my virgin super hub?

If you have an older Superhub the WPS button is that big blue glowing Virgin Media logo on the side.

How do I connect to WPS?

  1. On the supplied remote control, press the HOME button.
  2. Select Settings.
  3. Select Network.
  4. Select Network Set up or Setup Network Connections.
  5. Select Wireless, Wireless LAN or Wi-Fi.
  6. Select WPS (Push Button).
  7. Select Start.
  8. While the device is searching, press the WPS button on the router to establish a connection.

How do I put my super hub in modem mode?

How to enable modem mode on the Super Hub 1, 2 or 2ac

  1. Enter 192.168.0.1 into the address bar of your browser.
  2. The password is printed on the bottom of the Hub.
  3. Select Super Hub Settings to see the Modem Mode section.
  4. Select Enable Modem Mode.
  5. Select Yes to continue. The Super Hub will reboot and activate Modem Mode.

How do I connect my virgin box to my Smart TV?

Connecting to an HD TV Connect the HDMI cable provided into the HDMI port on the back of your TiVo box. Connect the other end to a free HDMI port on your TV.

How to connect Virgin Media Business super hub?

There are two ways to connect a WPS client device to the Virgin Media Business Super Hub. These are: Pairing by entering the WPS PIN codes into the two devices. The first of these will work if both devices each have a WPS button.

Where are the settings on Virgin Media Hub?

Use the settings printed on the back of the Super Hub to access the Super Hub settings area. For a guide on how to do this, please see Configure Advanced Settings on your Virgin Media Hub

How long does it take Virgin Media Hub to connect to WPS?

The Super Hub will try for up to two minutes to connect to the WPS client When the process is complete, the settings page should confirm that a connection was successfully made. The Virgin Media light on the Super Hub 2 should stop blinking and go solid blue

How can I connect my PC to the super hub?

To connect a PC using the WPS PIN code, which is useful if you’re not physically close to the Super Hub, do the following: Log into the Super Hub ‘User Interface’ as described previously, then navigate to the ‘Advanced Setting Menu’ from the overlay ‘User Interface’ Note: This cannot be used in routed sub-net mode as DHCP is switched off.