Where is the slave cylinder on a 93 Ford Ranger?
The clutch slave cylinder is located inside the transmission bell housing if it is “leaking” and cannot develop pressure the transmission has to be removed to replace the slave cylinder.
Where is the slave cylinder located on a 1994 Ford Ranger?
The clutch slave cylinder is located on the inside or outside of the transmission. If the slave cylinder is mounted on the outside of the transmission, it is normally attached by two bolts.
How do you remove a slave cylinder from a Ford Ranger?
Place a jack under the Ranger and lift it up. Depending on your height, the Ranger should be between 3 to 4 feet higher than normal. Crawl underneath the truck and remove the hydraulic line from the slave cylinder by twisting it counterclockwise and pulling it off.
How do I know if my slave cylinder is bad?
Symptoms of a bad clutch slave cylinder
- Clutch does not work.
- Clutch pedal sinks to the floor.
- Clutch pedal feels spongy, soft, or loose.
- Clutch pedal feels hard.
- Gears grind while shifting.
- Gears are hard to shift.
- Gears will not shift.
- Clutch fluid low and/or leaking.
How long does it take to change a clutch on a Ford Ranger?
Replacing the clutch in your Ford Ranger is fairly simple and takes about two hours. Your Ranger’s clutch should be replaced every 90,000 to 100,000 miles, sooner if it the clutch plate shows wear or fails.
How do you remove a hydraulic cylinder on a Ford Ranger?
Place a jack under the Ranger and lift it up. Depending on your height, the Ranger should be between 3 to 4 feet higher than normal. Crawl underneath the truck and remove the hydraulic line from the slave cylinder by twisting it counterclockwise and pulling it off. To reinstall the hydraulic line, simply reconnect it and twist it clockwise.
How to remove the hydraulic slave cylinder line on a Ford?
Crawl underneath the truck and remove the hydraulic line from the slave cylinder by twisting it counterclockwise and pulling it off. To reinstall the hydraulic line, simply reconnect it and twist it clockwise.
Where does clutch fluid leak in Ford Ranger?
Fix: Clutch fluid can only leak from three places: master cylinder, slave cylinder, lines. Check at the firewall where the master is mounted for signs of leaking first. This will indicate a bad master cylinder seal. Check along the lines as well.
How do you lift up a Ford Ranger?
Park the Ranger on a flat, level surface and apply the truck’s parking brake. Place a jack under the Ranger and lift it up. Depending on your height, the Ranger should be between 3 to 4 feet higher than normal. Crawl underneath the truck and remove the hydraulic line from the slave cylinder by twisting it counterclockwise and pulling it off.
