What is the best way to hang curtains in a bay window?

To hang curtains in a bay window, use three separate curtain rods and put the curtains through each. One large curtain can work so long as they aren’t opening and closing constantly. Opt for long curtains if the windows almost reach the ceiling.

How do you put a cord on a curtain track?

Draw the cord until the right hand carrier 1 is as far to the right as possible. Holding the cords taut, push carrier 2 as far to the left as possible. Hook cord over the lug on carrier 2 to secure it. Replace sliders at each end.

How do you add cord to curtain tracks?

The smaller slides flank the carriers on either side and can be added or removed when needed. Push the cord over the top left pulley, pull it through the upper carrier and tie a knot to secure it. Feed the opposite end of the cord between the two pulleys on the left and secure under the carrier on the right.

How do you remove cord from curtain rod?

If you’re removing an old cord, you can untie it from the carriers and pull it out, then push the carriers, also known as “master slides,” to the center of the rod. The smaller slides flank the carriers on either side and can be added or removed when needed.

Why are corded curtains so hard to pull?

This is bound to reduce the efficiency of the track and make the pulley difficult to pull. When the weight of the curtains is added it exagerates the problem and, depending where the crossover of the cord lies, the curtains may stagger, or maybe not travel very far.

How can I repair the pull cord on my blinds?

Step 8: Pull on the other cord that is hanging from the headrail until the newly joined bit can be seen at the cord separator. Step 9: Take the plug away from the bottom rail. Step 10: Start pulling the knotted end of the cord away from the bottom rail. This will allow the new cord to pass through the ladder into the bottom rail.