What type of cable is used for boat lifts?
Galvanized steel cables are the most common type of cable. Galvanized steel cable is stronger than stainless steel cable. Breaking Strength = 7,000 lbs Most commonly used cable for boat lifts.
Where is the model number on a Shorestation boat lift?
If you need a repair on any model made before 2021, you will need some measurements to order repair parts for your Shorestation lift. First, look in the area marked to see if you can find the model number It’s usually on a yellow sticker.
Should you lubricate boat lift cables?
Lubricate a Cable Lift’s Moving Parts Motors and their parts should be oiled using an anti-corrosion lubricant at least twice a year, depending on use. Cables should be sprayed lubricated every so often. If frayed or broken cables are detected, a boat lift repair technician should be contacted immediately.
Where do I find my Shorestation model number?
First, look in the area marked to see if you can find the model number It’s usually on a yellow sticker.
How do I find my shore station model?
The easiest thing to do is measure the height of the lower framework on the lift. The extrusions that connects each upright should measure roughly 2” wide x 4” tall for a 2600 or 3000 lb capacity and should measure roughly 2” wide x 5” for a 3600 or 4000 lb capacity.
How do you keep tension on a boat Cable?
Lowering the lift too far down so that it sits on the bottom of the boat slip which releases the tension from the cables. Too much buoyancy from wooden bunks can also release too much tension from the cables which would cause unspooling. Installation of weights or conversion to aluminum bunks is a recommended solution.
How much does it cost to replace a boat lift cable?
Replacement Aftermarket Lift (Split) Cable- Galvanized Steel for ShoreStation® brand lifts 26/30/36/4000lb. Lifts-108″ or 120″ Width- $170.00 plus tax Replacement Aftermarket Stainless Steel Leveling Cable for ShoreStation® brand lifts 26/30/36/4000lb. Lifts-108″ Width- $165.00 plus tax
What kind of cable do I need for my shorestation lift?
Looking for a replacement cable for your ShoreStation Lift? Check out our complete selection of ShoreStation Repair Cables here. Cables are specifically designed to properly fit designated lift models. Most cables are available in your choice of Galvanized Steel or Stainless Steel cable materials.
What kind of cable do I need for my lift?
Check out our complete selection of ShoreStation Repair Cables here. Cables are specifically designed to properly fit designated lift models. Most cables are available in your choice of Galvanized Steel or Stainless Steel cable materials. ShoreStation 5/8″ Shoulder Nuts (Pair) – 1… ShoreStation Non-OEM Stainless Winch Cable…
Where does the lift cable go in a winch?
Make a note of which cable goes above and below the pulleys. The winch cable goes around the pulley low (but exits the tube high) and the lift cable goes around the pulley high (but exits the tube low). With the pulleys out of the way, you can see the eye of the winch cable, and the bolt that holds it in place.
