Why does my DSC alarm keep beeping?

The culprits may be a low battery (1), bell circuit (2), system trouble (3), system tamper (4), module supervision (5), RF jam detected (6), PC5204 low battery (7), or PC5205 AC Failure. If the beeping keeps on beeping and beeping, however, you’ll probably have to replace the battery.

How can I change my master code in DSC 1555?

The DSC Security System PC1555: How to Change the Master Code

  1. Press the “*” (asterisk) key on the main control unit and tap the “<” or “>” button until “Access Codes” appears on the display.
  2. Press “5” or “*” to enter the code menu.
  3. Press “*” when “User Code 40P” appears on the screen.

How do I reset my DSC alarm?

Power up the panel, wait 10 seconds and power down. Then disconnect the jumper, and power the system back on. Performing a factory default will restore all system settings to their default.

How do I permanently disable my DSC alarm?

How Do I Disarm My DSC Alarm System?

  1. Disarm from the panel. To disarm from the panel, simply enter in a valid user code or the Master Code.
  2. Disarm with a key fob. To disarm using a key fob simply press and hold the disarm button on a programmed key fob while within range of the system.
  3. Disarm through Alarm.com.

How do you clear the memory on a DSC alarm system?

To clear the memory, arm and disarm the system. Certain sensors (such as smoke detectors and glass break detectors) have to be reset after an alarm. To reset detectors, press and hold the RESET key () for 2 seconds.

How do I reset my DSC panel?

How to Reset a DSC Alarm After the Power Has Been Off

  1. Open the access door on the unit.
  2. Press and hold the “RESET” key for 2 seconds.
  3. Press the buttons “*72” if the alarm does not reset after pressing the RESET button.
  4. Check the sensors if it still does not turn off.

How do you fix a beeping house alarm?

Solution: Replace or remove battery

  1. Step #1: Locate the alarm control panel.
  2. Step #2: Open the control panel.
  3. Step #3: Identify the battery.
  4. Step #4: Disconnect the battery from the circuit board.
  5. To reconnect a new battery, do the following.
  6. To leave the system disconnected, unplug the transformer.

How to test your DSC pc1555 alarm test?

Page 15 Testing Your System Alarm Test The Alarm Test provides two second test of the keypad sounder and bell or siren. Begin with the panel in the Ready state. From an LED keypad, Enter [ ] [6] [Master Code] [4] then press [#] to return to the Ready state.

How to disarm a DSc pc1555 keypad?

If motion is detected in the interior zones, or if one of the perimeter zones is violated, the alarm sequence will begin. Page 8 Disarming the System Disarming from an LED Keypad: Enter the premises through a designated Exit/Entry door; entering by any other door will sound an immediate alarm.

Where can I find the DSC control panel?

Page 3 02LS2 Ringer Equivalence Number: 0.1B Your security system is made up of a DSC control panel, one or more keypads and various sensors Service Order Code: 9.0F and detectors. The control panel will be mounted out of the way in a utility closet or in a basement.

When to use away arming in DSC pc1555?

Page 7 Alternate Arming Methods Away Arming Arming the system in the Away mode will have all interior zones and perimeter zones active. If motion is detected in the interior zones, or if one of the perimeter zones is violated, the alarm sequence will begin.