Is LA-2A a tube compressor?
The LA-2A is a hand-wired, tube-based compressor. It uses an electroluminescent panel together with a cadmium-sulfide light dependent resistor to provide gain reduction, which in the LA-2A’s own terminology is called the T4 cell.
Is LA-2A optical compressor?
This optical attenuator, known as the T4, is what gives the LA-2A its gentle, program dependent optical compression, revered to this day by audio professionals worldwide.
Is LA-2A a stereo?
The LA2A is a real classic tube-powered Opto compressor/limiter. Of all the compressors, this one can be the most transparent and great sounding on vocals, and in stereo mode is one of the secret weapons of mastering engineers.
What is LA-2A good for?
The UREI-built Silver LA-2A is generally appreciated for its faster time constant and its treatment of transients. This makes it a versatile performer that’s suitable for the widest variety of applications — including drums, percussion, and bass guitar.
Is LA2A a tube?
The amp section of the LA2A is a negative feedback tube amplifier designed around a 12AX7 and a 12BH7 tube.
What ratio is LA2A?
Although the compression position on the compress/limit switch on the LA-2A is considered 4:1, really the ratio will fluctuate depending on the source. The LA-2A has a frequency dependent attack, with an average attack time of 10 milliseconds.
Who owns Teletronix?
Teletronix LA-2A by Universal Audio The LA-2A was originally produced in the early 1960s by Teletronix, which was later acquired by Babcock Electronics Corporation.
How many rack spaces is an LA-2A?
The 2-LA-2 is housed in a standard two-rackspace 19″ chassis, and so we recommend that it be securely mounted in a rack if possible.
What does the LA-2A compressor do?
It’s brilliant as a permanent fixture in your vocal compression chain. In series with another compressor (the 1176 is a popular choice), the LA-2A helps deliver silky-smooth vocals. Hit the ‘2A hard to smooth out the largest peaks, then run the signal through the 1176 to tidy up.
What tubes are in an LA-2A?
Testing for the LA-2A Classic Leveling Amplifier
- There are two tubes in the amplifier section, and two tubes in the compression section.
- For compression problems, check the tube at the 6AQ5 marking, and the tube at the 12AX7 marking on the center-left side of the unit.
What ratio is LA-2A?
Is there a plug in for the Universal Audio LA-2A?
Every serious studio needs at least one. We at Sweetwater can attest to the fact that there’s no shortage of LA-2A plug-ins — testimony to the hardware unit’s enduring relevance, sonic appeal, and dynamics-control prowess.
Is the UA LA-2A a go to compressor limiter?
There isn’t really too much to say here other than the UA LA-2A is one of those compressors which has withstood the test of time again and again. Countless artists, producers and engineers have relied on the LA-2A for decades as the industry standard go to compressor limiter.
What kind of bass does the LA-2A compressor do?
A studio staple for over a half century, the LA-2A continues to captivate new generations of retro-seeking audio pros with its uncanny ability to work its magic on synth bass and 909 kick samples, in addition to its decades-long dominance as the non plus ultra compressor for vocals, bass, drums, guitars, and anything else you might care to feed it.
When did the Universal Audio Teletronix LA-2A come out?
First introduced in the early 1960s, the Teletronix LA-2A Leveling Amplifier fast became a staple in the racks of recording and broadcast studios large and small. Today, the Universal Audio LA-2A is crafted to original specifications in Scotts Valley, California, handwired point-to-point, with every component carefully selected for authenticity.
