How do I reset my toner counter?

Reset process

  1. Switch-off the printer.
  2. Press and hold the on/off button.
  3. When all the LEDs turn on, open the cover and remove the toner cartridge + drum unit.
  4. Release the on/off button.
  5. Re-install the toner cartridge + drum unit back into the printer and close the printer cover.

How do you reset the toner level after installing a new cartridge?

While the printer is at Ready, press the Menu button until you see Test Menu. Press Select….Reset the toner level.

  1. Press the Menu> button until Reset Toner Lvl appears on the display and then press the Select button.
  2. Press the Menu> button to scroll through each of the four colors that are to be reset.

How do I reset my brother tn 420 toner?

Press the “Go” button 2 times – The “Toner, Drum, and Error” LEDs will turn ON. Press the “Go” button 6 times for a TN420 or Press the “Go” button 7 times for Brother TN450. Close the front cover after “Error” LED starts to flash. Finally, The reset procedure has been completed.

How do I reset my brother Toner HL-1110?

When a new TN1070 toner is installed in a Brother HL-1110 or HL-1210W printer, a reset gear turns and triggers a switch to reset the toner counter….It’s very easy to do:

  1. Press the power button 7 times to enter continue mode.
  2. Done.
  3. If you want to exit continue mode press the power button 7 times.

How do you reset the toner on a Brother DCP 1510?

Toner Reset Instructions For DCP1610W and DCP1510

  1. Press the MENU button.
  2. Hit the down arrow until you see info on the display.
  3. Press the OK button.
  4. Hit the down arrow until you see reset drum on the display.
  5. Press and hold the OK button until you see reset on the display.
  6. Press the START button.

How do I get my toner to work again?

Usually, toner cartridges have a small sensor hole on the non-gear side of the cartridge….Covering this up with a small piece of electrical tape is the trick you need to bring your printer back to life.

  1. Remove and Shake The Cartridge.
  2. Replace Toner.
  3. Redistribute Toner.
  4. Troubleshoot Printer.
  5. Stock Up on Supplies.

How do I reset my brother tn 450 toner?

  1. Turn off power to the printer.
  2. Open the front cover to the toner/drum section of the printer.
  3. Press and hold the “Go” button while turning on power to the printer.
  4. Release the “Go” button after “Toner, Drum, and Error” LEDs turn on with the “Ready” LED turn off.