What is the reed switch in an EZ Go golf cart?
Reed Switches are used to prevent cart operation with the charger plugged in. They have become increasingly expensive and they are very fragile. this component is used to eliminate the reed switch from the electrical system.
Where is the microswitch on a ezgo golf cart?
On EZGO gas golf carts, the accelerator micro switch is located behind the forward-reverse lever and right below the seats under the mat near the accelerator pedal. You can access the EZGO accelerator micro switch by removing the four P1 Phillips screws that hold the top covering in place.
How do you test a reed on a golf cart?
A simple way to check for a bad reed switch is to run a jumper wire from the main microswitch on the F/R to the main positive. This is ONLY A GOOD TEST. If your cart shows to have a bad reed switch, then replace it.
How do I speed up my EZ Go gas golf cart?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.
How do I bypass the reed switch on my EZ GO?
Cut the thin white Reed switch wire as close to the Reed switch itself as you can. Discard Reed switch. Install an eyelet on the newly cut white wire and attach it to the A(+pos) connection of the cart charger receptacle (where the thin red wire used to be). Your Reed switch is now bypassed.
How do I troubleshoot my EZ Go golf cart?
Things to Keep in Mind Before Troubleshooting
- EZGO golf cart batteries aren’t perfect right away.
- Sticky accelerators are perfectly normal and can be fixed easily.
- Keep your cart stable.
- Make sure your charging wall socket isn’t faulty.
- Keep your tire pressure stable.
- Troubleshooting the speed controller.
What can I use instead of a reed switch?
The Hall effect sensor is a solid-state device that can detect magnetic fields, and it is one alternative to the reed switch.
What is the wiring diagram for an EZGO golf cart?
36 Volt Ezgo Golf Cart Ignition Switch Wiring Diagram | Wiring Diagram – Ezgo Wiring Diagram The diagram offers visual representation of a electrical structure. On the other hand, the diagram is a simplified version of the arrangement.
Where are the reed valves on a golf cart?
Golf Car Catalog offers reed valves and breather valves for EZGO, Club Car, Yamaha, Columbia, and Harley golf carts. A reed valve is unique to a 2 cycle engine and is located between the carburetor and the engine. As the fuel is forced through the carburetor into the engine, this forces the reed valve open.
What is the breather valve on a golf cart?
A breather valve is more specific to 4 cycle golf cart engines and is used to release pressure from the crankcase, Since the air produced here is toxic, it is typically routed back to the carb or air cleaner to be combusted again. The breather valve gasket helps to seal the breather to the engine case.
What does the black dot mean on an EZGO wiring diagram?
According to previous, the traces at a Ezgo Wiring Diagram represents wires. Sometimes, the wires will cross. But, it doesn’t mean link between the cables. Injunction of two wires is usually indicated by black dot on the intersection of two lines.
