How much wider are Gu diffs?

GU diff is physically alot bigger than GQ, with bigger diff head, longer tubes and axles (but same dia as GQ), bigger dia and thicker brake rotors, and of course is about 40-50mm wider overall.

Are all GU diffs the same?

Registered. GU and GQ diff center is the same (if they are both H233), except GQ RD28 and RB30 has smaller flange, but can be swap over easy. The whole diff (hub to hub) is different, GU is wider and has larger CV.

Are GU diffs better than GQ diffs?

Yes they are a straight bolt in mod. The housings are slightl wider but the best bit is the CV’s are about 2cm bigger than a GQ and HEAPS stronger. You break at least one GQ CV per comp (average) but you can go years of comp work (as BIG RED had) and not break on GU CV.

What is a H260 diff?

H260 is a much bigger diff. The ring gear on a 260 is 10.24 as opposed to 9.17 on a 233. The number is the ring gear size in millimeters. The bigger diff comes on some Nissan truck as well as the Patrol pickup and some GUs. J.

How wide is a Hilux diff?

The closest fit for an Escort is the Hilux 2WD diff from RN10, RN15, RN20 & RN25 models manufactured during the first half of the 70’s. Each of these has the same spring centres (940mm) and overall width (1350mm) as an Escort.

Are Hilux and Prado diffs the same?

The Hilux and the Prado 120 run a 8″ front diff crown wheel and the earlier Prado 90 had a 7.5″ Crown wheel. Apparently the rear diffs on the Prado 90 are the same but they might have a different flange to bolt the drive shaft on to but you can swap your flange over.

Does my Hilux have ADD?

Jack up the front end and spin one tire by hand. If the other tire spins in the same direction, you have an LSD. Examine the area next to the front differential. If you have a square housing and actuator (it will have a vacuum line attached to it) like the pictures below, you have the Toyota ADD system.

How do you know if a differential ratio is e36?

The ratios are also stamped on the tags, which is usually on the top right diff cover bolt. they usually have two numbers then the ratio i.e 315 294 etc.