Where is the crank angle sensor located?

The sensor is at either the front or the back of the crankshaft, so it’s usually located either on the transmission bellhousing or behind the crankshaft pulley. There should be a small air gap, usually about a millimeter or two, between the sensor and the reluctor.

What is fault code P0335?

What Does P0335 Mean? Crankshaft position is used to inform the Engine Control Module (ECM) of when it is time to spark and deliver fuel. Trouble code P0335 is set whenever the ECM does not sense crankshaft pulses or senses a problem with the pulses in the output with Sensor “A” Bank 1.

What does the code P0335?

The OBD-II code P0335 is a generic diagnostic trouble code that stands for “Crankshaft Position “A” Circuit Malfunction.” The code is set when your car’s primary computer—also known as the powertrain control module (PCM)—is unable to detect a signal from the crankshaft position sensor.

What is P0335 engine code?

What does trouble code p0335 mean on Altima?

When the Altima’s ECM determines that there is an issue with the signal coming from this sensor, it’ll throw the P0335 trouble code. Depending on the model year and engine of any vehicle the job of the crankshaft sensor is going to change.It’s either going to provide info to the ECM to keep the vehicle from misfiring.

What is the crankshaft sensor on a Nissan Altima?

Nissan Altima P0335: Crankshaft Position Sensor “A” Circuit Malfunction. The Nissan Altima utilizes a crankshaft position sensor in order to regulate the engine timing. This sensor uses a reluctor to gauge the position of the crank.

Why is the p0335 thrown on the road?

The crankshaft sensor is often the reason that P0335 is thrown. They aren’t very expensive, but they can be difficult to get to in order to service them. If you think you’re up to the challenge (and know how to use a volt meter) this guide from doityourself.com will show you exactly how to test the sensor.

What causes a Chevy Cruze to throw a p0335?

Most of the time, the crankshaft sensor is going to be the cause of P0335, or the wiring will be at fault. There are other causes as well.There’s more on that directly below. The crankshaft sensor is often the reason that P0335 is thrown.