Why is my fan working but not the light?
When you discover a ceiling fan light doesn’t work, confirm that electricity is reaching the room. Test your fan to see if the blades rotate when turned on. If the blades turn, check the switch that controls the ceiling fan light. Reset the breaker and then test the ceiling fan light and blades.
Why is my ceiling light not working?
First check the bulb. Tighten the bulb if it is loose, then try the switch again. If a problem remains, be sure the switch is off, remove the bulb and substitute a new one. If the light does not work with a new bulb, check whether the circuit breaker or fuse governing the fixture has tripped or blown.
Do ceiling fan lights have fuses?
If the latter, you may have blown an inline fuse that some ceiling fans have for the lights. If you turn off the power and remove the small canopy that the lights fasten to, you may see a cylindrical plastic fuse holder with a wire going in each end. It opens up so you can access the fuse.
Why would a light fixture suddenly stop working?
Chances are, your lights have stopped working because of one these four common reasons: The light fixture was unplugged. The light bulbs burnt out. The circuit breaker or GFI got tripped.
How do you troubleshoot a light not working?
If the light bulb does not light up at all, follow this troubleshooting procedure:
- Check the light bulb first to see if it has burned out.
- Check to see if the bulb is tight in the socket.
- Check the metal socket tab in the bottom center of the socket.
- Check the connections at the switch and make sure that they are tight.
Are LED lights repairable?
LED tail lights have a high failure rate. Fortunately, they’re easy to repair or replace as a do-it-yourself job. Although LED tail lights are designed to last, moisture may enter worn housings and could corrode circuit boards, causing the resistors to fail. This will lead to LED burn out or dimming of the bulb.
Why is my Hunter ceiling fan not working?
Another possible cause is when a fan is wired to a dimmer switch. If the noise is more like a buzz then it could be a capacitor that has failed although this is rare as Hunter use very high quality capacitors. If the fan is really old then it could also be motor laminates breaking down.
How do you troubleshoot a hunter ceiling fan?
In terms of troubleshooting a Hunter ceiling fan remote control, much of the troubleshooting will be similar to troubleshooting other fans: Turn power on to the fan. Try using the remote to turn on the fan. If you cannot get the fan to turn on at all using the remote, pull on the pull chain and set the fan to the highest speed.
Why does a ceiling fan light doesn’t work?
If the fan blades and the ceiling fan lights don’t work, the problem might be that power isn’t getting to the room. Check a nearby outlet to see if it has power. If power is out for the entire room, go to your main electrical panel and locate the circuit breaker for the area. Reset the breaker and then test the ceiling fan light and blades.
