Can I connect RP-SMA to SMA?

This is an adapter that converts an RP-SMA board to an SMA antenna. The adapter will connect to any of our 2.4GHz wireless boards (Bluetooth, Nordic, or XBee) or interface cables and will allow you to use an antenna/cable with an SMA connection.

Is RP-SMA the same as SMA?

RP-SMA stands for “reverse polarity” (sometimes also referred to as reverse SMA or for short “R-SMA”). The RP-SMA female socket has a barrel with external threads and a centre pin. When they are plugged, the two are indistinguishable and the signal quality is the same.

What is SMA female connector?

SMA (SubMiniature version A) connectors are semi-precision coaxial RF connectors developed in the 1960s as a minimal connector interface for coaxial cable with a screw-type coupling mechanism.

What is a RP SMA connector?

Reverse polarity SMA (RP-SMA) is a variation of the SMA connector specification which reverses the gender of the interface, as shown in Figures 1-4 below. Similarly, the RP-SMA(M) has threads on the inside like a conventional male, but has a center receptacle instead of the male pin in the middle.

Is SMA the same as 3.5 mm?

SMA and 3.5mm are matable connectors. The SMA connector is an economical, lower performance interface. SMA type will have a foam bead, while 3.5mm uses an air interface. Due to cost, the 3.5mm connector is most often used in metrology applications, whereas the SMA connector is used for production.

Which is correct RP-SMA male or female?

RP-SMA gender is counter-intuitive: Please observe picture & note it is correct. The gender is referring to the pins inside–not the threads. RP-SMA male has threads on inside. RP-SMA male has a socket inside rather than a pin, as you might expect, because the RP stands for “Reverse Polarity.”

Which is the SMA male to female adapter?

weBoost 971119 FME Male to SMA Male Connector is an adapter that is used to connect an SMA female connector to a TNC female connector. It can be used to connect a Wilson mobile antenna or direct connect amplifier to a cell phone antenna port.

What kind of connector is a RP-SMA?

RP-SMA is a round screw-type connector, with medium-sized, threaded coupling connectors that are rated for frequencies from the lowest (DC) up to 18GHz. We offer an RP-SMA wrench to assist in installing antennas, cables and adapters with RP-SMA or SMA connector (s).