What is the e-coat process?
Electrocoating is a process by which electrically charged particles are deposited out of a water suspension to coat a conductive part. During the electrocoat process, paint is applied to a part at a certain film thickness, which is regulated by the amount of voltage applied.
What is E coating made of?
The e-coat bath consists of 80-90% deionized water and 10-20% paint solids. The deionized water acts as a carrier for the paint solids, which are under constant agitation.
What is an e-coat kettlebell?
The e-coat kettlebells are made of ductile iron, are painted electronically, and have a glossier surface which makes them more durable and easier to clean. The powder coat kettlebells are made of cast iron, are painted with a dry powder, and are textured which gives them a better grip for a better price.
Is e-coat a primer?
Most Original Equipment Manufacturer (OEM) parts come from the factory with a primer called e-coat. E-coat stands for Electro-deposition Coating. The part is dipped into a primer bath and the e-coat adheres to the part with the help of an electrical process. Most e-coat appears to be a glossy black coating.
Do you need to prime e-coat?
The application of a primer or sealer to the e-coat will bridge this cap. Although there is no way of fully preventing rock chips from happening, a sealed or primed surface will outperform an e-coated surface after impact by a large margin.
What is the difference between E coating and powder coating?
While e-coating is considered to be a “wet” process, powder coating involves the application of a dry powder consisting of a precise combination of epoxy resins and various curing agents. Curing causes the particles to melt and also serves as the catalyst for a chemical reaction that produces the desired finish.
What is 7 tank process for powder coating?
To me the 7 steps traditionally meant soak clean, rinse, acid, rinse, zinc phosphate, rinse, and chrome or chrome-free passivating dip.
What does low-E-coating do?
Low-E coatings have been developed to minimize the amount of ultraviolet and infrared light that can pass through glass without compromising the amount of visible light that is transmitted. When heat or light energy is absorbed by glass, it is either shifted away by moving air or re-radiated by the glass surface.
How do kettlebells prevent rust?
Regular maintenance should be performed to prevent corrosion from occurring. This is usually done by touching up any areas that are starting to rust (by sanding it down), and spraying kettlebells periodically with WD40 for additional rust protection.
How does the E-coating process work in paint?
The E-coat process is a dipping (immersion) system very similar to what is used in metal plating except the finish uses organic paint particles not metal particles in the immersion baths. [Back to top.] How does E-Coating work? Electro coating applications use paint particles suspended in a fluid bath.
What is electro coating and what does it mean?
What is Electro Coating? E-coating is an immersion wet paint finishing process that uses electrical current to attract the paint product to a metal surface. This process is also referred to as paint deposition.
How is post rinsing used in the E-coating process?
Post-rinsing, which occurs next, enhances the quality of the coating and enables the recovery of excess paint. During the e-coat process, paint is applied to a part using a regulated amount of voltage to achieve the desired film thickness. Once the coating reaches the prescribed thickness, the part “insulates” and the coating process slows down.
How is paint applied in the electrocoating process?
Read Next. Electrocoating is a process by which electrically charged particles are deposited out of a water suspension to coat a conductive part. During the electrocoat process, paint is applied to a part at a certain film thickness, which is regulated by the amount of voltage applied.
