What size belt goes on a 48 inch deck?
Husqvarna Deck Drive Belt fits 48″ Cut Decks No. Size: 5/8″ x 152″.
What size belt goes on a Craftsman 46 inch deck?
AYP / Craftsman / Sears Deck Belt fits 46″ & 50″ Decks. Size: 1/2″ x 88-3/4″. Replaces part number 158818.
How many belts does a Craftsman riding mower have?
The three primary belts found in a Craftsman mower are the drive belt, power clutch belt and arbor belt.
How long is a Husqvarna 48 inch deck belt?
Husqvarna 48-in Deck Belt for Riding Mower/Tractors (11/16-in W x 138.75-in L)
How do you adjust the belt on a Craftsman riding lawn mower?
Push the belt keepers on the transaxle pulley down and slide the belt over the transaxle pulley. Pull the slack from the back of the tractor (transaxle pulley) and slide the belt on to the stationary and clutch idlers. This will increase the tension in the belt and hold it in place.
What size belt do I need for a craftsman?
AYP / Craftsman / Sears Drive Belt No. AYP / Craftsman / Sears Drive Belt fits 42″ mowers, 12-18 HP. Size: 1/2″ x 92-1/4″.
How long is a craftsman deck belt?
AYP / Craftsman / Sears Deck Belt fits 42″, 46″ & 50″ Decks built since 1995. Size: 1/2″ x 95-1/2″.
How many belts are on a riding mower?
There are two belts on most riding lawnmowers. One belt connects the transmission of the lawn tractor to the driveshaft pulley and the other belt connects the mower deck to the driveshaft pulley.
What size belt does a Husqvarna?
Husqvarna 42-in Deck Belt for Riding Mower/Tractors (1/2-in W x 101.4-in L)
How do I replace the belt on my riding mower?
How to Change the Mower Deck Belt on a Riding Lawn Mower Step 1: Prevent unintentional starting Step 2: Adjust the deck height Step 3: Take off the mower deck belt guards Step 4: Take off the belt-keep rod Step 5: Loosen the idler pulley nuts Step 6: Snap a photo Step 7: Take off the mower deck belt Step 8: Install the new mower deck belt
How do I raise the deck on Craftsman riding mower?
Locate the height adjustment knob on the Craftsman garden tractor. You can find this height adjustment knob on the riding mower’s center console, directly below the wheel. It will be aligned to the left of this console area, below the ignition key. Turn the height adjustment knob clockwise in order to raise the cutting height of the mower deck.
What are the dimensions of the Craftsman belt?
Craftsman mowers have primary and secondary drive belts. Both belts range between 42 to 50 inches long, depending on the mower’s model. Craftsman’s riding and push mowers use drive belts.
