What size is the caliper mounting bolt?

The thread size, pitch, and length for the Caliper bracket bolts (2) are 14MM x 1.75 x 45mm. The thread size, pitch, and length for the bearing assembly bolts (3) are 14MM x 1.50 x 45mm.

What is caliper mounting bolt?

Proven Quality Carlson’s new, aftermarket caliper mounting bolts cover 150 million vehicles. Caliper mounting bolts attach the caliper bracket to the steering knuckle in both cars and trucks.

What is a caliper bolt called?

Remove them and your calipers fall off. They’re often called “caliper bracket bolts” because they attach to the part of your caliper called the bracket, and hold it tight to the spindle or steering knuckle.

Should you use Loctite on brake caliper bolts?

The repair manual says “Apply a high temperature thread locker (Loctite 272® or equivalent) to the caliper support bracket fasteners. If Loctite 272® (or equivalent) is not available, new caliper support bracket fasteners must be used.”

Are front and rear caliper bracket bolts the same?

Associate Member. Rear caliper uses two different bolts (!), one for the lower [9], another for the upper [8]; the front doesn’t use either of them. Not sure if there are the ones you’re looking for.

How much torque should a caliper bracket be?

The front brake caliper bracket should be tightened to 70 ft/lbs and the rear should tightened 85 ft/lbs. The caliper bolts have a torque spec of 44 ft/lbs and 23 ft/lbs in the rear.

Do you need to torque caliper bolts?

Do you need to torque caliper bolts? The only bolts that you need to be careful about are the caliper bracket bolts and they just need to be tight. Torque wrenches may seem like a luxury you don’t need, but they are actually used for a very specific, very important reason.

What is the difference between red and blue loctite?

The difference between red and blue threadlocker is a matter of strength and removability. Loctite threadlocker blue is designed to easily be replaceable with common tools, whereas red is a more permanent fix. For a hold that can be easily removed, Loctite Threadlocker Blue 242 is the hero.

How tight should caliper bracket bolts be?

Over torquing the caliper guide pin bolts: Caliper guide pin bolts typically need a 13mm wrench to remove. It is a rookie mistake to go nuts on these bolts and break the heads off. Typically these bolts require only 25- to 35-ft/lbs of torque. Be gentle!