What is Serial ATA connector?

The Serial ATA or SATA connector is used as an interface for connecting a host bus adapter to a mass storage device or optical drive. This connector was designed to replace the older connectors, 34-pin, 40-pin, etc. This connection is sometimes referred to as the SATA “L” due to the shape of the connector.

Where do you plug in Serial ATA?

Connect the Serial ATA cable to the primary or secondary Serial ATA connector on the motherboard or PCI card. The drive can be plugged into either. If the drive will be used as a boot drive, select the primary channel, as this is the first drive to boot between the Serial ATA connectors.

Is Serial ATA and SATA the same?

SATA stands for serial ATA and is basically a technologically advanced ATA drive with a few advantages. With data transfer rates reaching and exceeding 600MB/s, SATA can be much faster and more efficient than the 133MB/s capabilities of ATA drives.

What connector has 4 pins?

The ATX 4-pin power supply connector is a standard motherboard power connector used to provide +12 VDC to the processor voltage regulator.

What cables do a HDD need?

You’ll need a SATA cable to connect your new hard drive to your motherboard. SATA cable with a 90 degree plug on one end. You can get different options for the plugs on either end. One end of the SATA cable will plug into your new hard drive, and the other needs to go to a SATA port on your motherboard.

Is ATA hard drive compatible with SATA?

Although SATA hard drives cannot be directly installed in a computer that can only handle ATA drives, you can use an SATA drive in your current computer by purchasing an SATA controller card.

What is the difference between Serial ATA and SATA?

SATA or Serial ATA stands for Serial Advanced Technology Attachment and is the next generation computer bus interface from the parallel interface ATA. SAS, or Serial Attached SCSI, is a faster and historically more expensive interface.

What is Serial ATA Connection?

Serial ATA ( SATA, abbreviated from Serial AT Attachment) is a computer bus interface that connects host bus adapters to mass storage devices such as hard disk drives, optical drives, and solid-state drives. Serial ATA succeeded the earlier Parallel ATA (PATA) standard to become the predominant interface for storage…

What does ATA hard drive stand for?

ATA is the abbreviation of Advanced Technology Attachment, it can also be called IDE or PATA. It is a disk drive that integrates the drive controller directly on the drive itself. The computer can use an ATA hard drive without a specific controller to support the drive.

What is Serial ATA 150?

Serial ATA – or simply SATA – is the hard disk standard created to replace the parallel ATA interface, a.k.a. IDE. SATA provides a transfer rate of 150 MB/s or 300 MB/s against of a 133 MB/s maximum using the previous technology.