How much does a slurry seal cost?
Slurry seal costs about $. 60 per square foot and is very cost effective for many types of applications, when compared to a complete pavement overlay, which costs about $1.50 per square foot.
Is slurry seal any good?
Slurry seals are good for filling in minor voids and correcting raveling and other small imperfections. Sealcoating is preferable for lightly traveled or slower traffic areas, including parking lots and driveways.
How often should you slurry seal?
How long does a sealcoat last? The longevity of a slurry seal and sealcoat depends on traffic loading and weather. In general terms, you should reapply slurry every 6-9 years. You should reapply a sealcoat every 3-6 years.
How long does it take for slurry seal to dry?
Slurry Seal requires only a few hours to dry before traffic can drive over it but it takes 24 to 48 hours to cure completely.
How much does slurry cost?
Apply Slurry Seal: national average cost
| cost to apply slurry seal | |
|---|---|
| National Avg. Materials Cost per square foot | $0.28 |
| National Avg. Cost (labor and materials) for 500 square foot | $308.39 |
| National Cost Range (labor and materials) for 500 square foot | $232.89 – $383.88 |
Is slurry seal a cold mix?
Slurry seal is a cold mix paving system that can remedy a broad range of problems on streets, airfields, parking lots, and driveways. The principal materials used to create slurry are aggregate, asphalt emulsion, and fillers which are mixed together according to a laboratory’s mix design formula.
When can you drive on slurry seal?
The street is opened for driving after 4-5 hours. Weather conditions may impact the slurry and cause delays in the street opening. i.e. extreme heat makes the slurry too soft, therefore, driving on it would not be permitted until later.
Can you walk on slurry Seal?
Typically, you can walk on slurry seal the same day it is placed. Shady areas will take longer to dry and should be avoided.
How much does it cost to slurry a house?
The national average materials cost to apply slurry seal is $0.28 per square foot, with a range between $0.26 to $0.30. The total price for labor and materials per square foot is $0.62, coming in between $0.47 to $0.77. A typical 500 square foot project costs $308.39, with a range of $232.89 to $383.88.
What is Type 2 slurry seal?
Type II slurry uses 1/4” aggregate and is commonly used to seal, correct moderate to severe raveling, oxidation damage and loss of matrix, as well as improving skid resistance. It is the most commonly used slurry seal and is widely employed where moderate to heavy traffic is found.
How long does it take for street tar to dry?
First of all, there is often confusion between “curing” and “drying.” Asphalt takes six to twelve months to fully cure, and remains a little more susceptible to damage for that time. However, it takes 48 to 72 hours to “dry” enough for foot and vehicle traffic. This is for new asphalt.
